Draft Details

1.1
This Standard specifies the mechanical, electrical, and performance control requirements for integrated hydrogen fueling station (HFS) equipment (HFS modules) which transfer hydrogen from a source to vehicles with hydrogen fuel storage systems.

This Standard includes requirements for light, medium and heavy-duty vehicle fueling, including vehicles with H35, H70, LH2 and CcH2 fuel storage systems. 

Note: This Standard includes an informative annex A that provides methods to evaluate the hourly and daily capacity of an installed HFS.

1.2 
Unless otherwise stated, the standard conditions are as follows: temperature 15 °C and pressure 101 kPa.

1.3 
In case of conflict between this Standard and federal, provincial, state, or local regulations, governmental regulations take precedence.

1.4 
All references to pressure throughout this Standard are to be considered gauge pressure unless otherwise specified.

1.5 
In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; “may” is used to express an option or that which is permissible within the limits of the Standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text or explanatory informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.

1.6 
The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only