Draft Details

Designation:C22.2 NO. 250.570
Source:CSA
Review start date:Jan 25, 2024
Review end date:Mar 25, 2024
Categories:Electrical
Contact email:mary.morgan(at)csagroup.org
Draft Scope/Description:

Scope has changed and clause renumbering throughout the document.

Please see changes in the Preface. 

1.1

The requirements specified in this Standard apply to wall and ceiling-mounted track lighting systems, intended to be installed in non-hazardous, dry locations in accordance with the Canadian Electrical Code, Part I.

These requirements cover:

a) permanently installed track systems;
i) rated 347V or less, 40A max;
ii) 
supplied by a power source with an output of 30 Vrms or 42.4 Vpeak or Vdc and less than 240 VA;
iii)or 
supplied by a Class 2 power source;
b) permanently installed lighting systems employing bare conductors supplied by a power source with an output up to 30 Vrms or 42.4 Vpeak or Vdc, and less than 240 VA;
c) extra-low-voltage suspended ceiling grid systems that operate up to 30 Vrms or 42.4 Vpeak, connected to a Class 2 power source;
d) luminaire assemblies incorporating incandescent, fluorescent, light emitting diodes and high-intensity discharge lighting sources; and
e) canopies, and other accessories.

Note: See Rule 30-104 of the Canadian Electrical Code, Part I for the maximum rating of overcurrent protection.

1.2
The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only.

1.3
In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.