Draft Details

Designation:ASSE 1003/CSA B356
Source:CSA
Contact name:Sarah Chung
Review start date:Aug 2, 2022
Review end date:Oct 1, 2022
Contact email:thuy.ton(at)csagroup.org
Draft Scope/Description:

1.1 General 

This Standard applies to water pressure reducing valve for potable water distribution systems. The purpose of a water pressure reducing valve for potable water distribution systems (herein referred to as the “device”) is to reduce static and flowing pressures in water distribution systems.

1.2 Sizes

This standard applies to nominal device sizes of 1/2, 3/4, 1, 1-1/4, 1-1/2, 2, 2-1/2, 3, and 4 inches (DN15, DN20, DN25, DN32, DN40, DN50, DN65, DN80, and DN100).

1.3 Terminology 

In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (nonmandatory) to define their application.

1.4 Units 

SI units are the units of record in Canada. In this Standard the inch/pound units are shown in parentheses.

The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard.

All references to gallons are to U.S. gallons.

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.