Draft Details

Designation:ISO 19085-11
Source:ISO
Review start date:Mar 25, 2022
Review end date:May 24, 2022
Categories:Electrical
Contact email:mary.morgan(at)csagroup.org
Draft Scope/Description:

1 Scope

This document gives the safety requirements and measures for stationary and displaceable combined woodworking machines, having at least two separately usable working units and with manual loading and unloading of the workpiece, hereinafter referred to as “machines”. The integrated working units can be of these types only:

— a sawing unit;
— a moulding unit;
— a planing unit.

The machines are designed to cut solid wood and material with similar physical characteristics to wood.

NOTE 1 For the definitions of stationary and displaceable machines, see ISO 19085-1:2017, 3.4 and 3.5.

This document deals with all significant hazards, hazardous situations and events as listed in Clause 4, relevant to the machines, when operated, adjusted and maintained as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse. Also, transport, assembly, dismantling, disabling and scrapping phases have been taken into account

NOTE 2 For relevant but not significant hazards, e.g. sharp edges of the machine frame, see ISO 12100:2010.

This document does apply to machines also equipped with the devices/additional working units listed in the Scopes of ISO 19085-5:2017, ISO 19085-6:2017, ISO 19085-7:2019 and ISO 19085-9:2019.

This document does not apply to:

a) machines incorporating only a planing unit and a mortising device;

NOTE 3 Such machines are dealt with in ISO 19085-7:2019.

b) combined machines incorporating a band saw unit;

c) machines with a mortising unit with a separate drive other than the planing unit drive;

d) machines intended for use in potentially explosive atmosphere;

e) machines manufactured before the date of its publication as an International Standard.

1DV Modify Clause 1 by adding the following to the first paragraph:

This Standard applies to combined woodworking machines that are intended to be installed and used in accordance with the National Electrical Code (NFPA 70) in the United States and the Canadian Electrical Code, Part I (CSA C22.1) in Canada.

In Canada, general requirements applicable to these machines are provided in CSA C22.2 No. 0.

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.