Draft Details

Designation:LNG 3.12
Contact name:Mark Duda
Review start date:Mar 23, 2022
Review end date:May 22, 2022
Contact email:kelly.yaremko(at)csagroup.org
Associated materials (click link to download). You will need to be logged in to download any files:

Adobe Acrobat For PDF files, Adobe Acrobat Reader can be downloaded from the Adobe website.

Draft Scope/Description:

[Replace the scope with the following]

This document specifies tests and requirements for the rigid fuel line in copper and its alloys, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in:

In Canada: CSA B109.2.

In the United States: NFPA 52.

It also provides general design principles and specifies requirements for instructions and marking.

This Standard is not applicable to the following:

a) fuel containers;

b) stationary gas engines;

c) container mounting hardware;

d) electronic fuel management; and,

e) fuelling receptacles.

It is recognized that miscellaneous components, not specifically covered herein can be examined to meet the criteria of this Standard and tested according to the appropriate functional tests.

All references to pressure in this Standard are to be considered gauge pressures unless otherwise specified.

This Standard is based upon a working pressure for natural gas as fuel of 1.6 MPa (232psi). Other working pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, a 2 MPa (290psi) working pressure system will require pressures to be multiplied by 1.25.

[Add the following note]

NOTE 3A For North American application, all references to working pressure are considered to be equivalent to maximum allowable working pressure (MAWP).

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.