Draft Details

Review start date:Jan 7, 2020
Review end date:Mar 7, 2020
Contact email:sue.ruscetta(at)csagroup.org
Draft Scope/Description:



This Standard specifies requirements for profile polyethylene (PE) storm sewer and drainage pipe and fittings for gasketed and non-gasketed leak-proof applications. The products covered under this Standard may be manufactured using either virgin or recycled (post-industrial or post-consumer) materials.

Profile wall pipe includes both open and closed profile with smooth interiors and sizes based on controlled inside diameter. Open profile pipe is of an annular construction. Closed profile pipe is of an annular or helical construction.


1) Pipe and fittings manufactured in accordance with this Standard should be installed in accordance with CSA B182.11.

2) Refer to Annex A for recommended quality control test frequencies.

3) Refer to Annex G for additional minimum quality control test frequencies for pipes made with recycled materials.

4) Refer to Annex C for fitting patterns of the lay length of fittings covered by this Standard.

5) Annex F should be followed to ensure that the requested products are described adequately.


This Standard does not cover helical open profile pipe.

Note: The ESCR requirements of this Standard can be unsuitable for helical open profile pipe.


This Standard does not cover 210 kPa pipe in sizes smaller than NPS-12.


In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard.

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.