Draft Details

Designation:C22.2 NO. 110
Source:CSA
Review start date:Apr 30, 2019
Review end date:Jun 29, 2019
Categories:Electrical
Contact email:mary.morgan(at)csagroup.org
Draft Scope/Description:

1.  Scope

1.1

This Standard applies to both cord-connected and permanently connected storage-tank water heaters*, having tanks less than 610 mm inside diameter, for use on nominal system voltages of 600 V and less, and designed to be used in nonhazardous household and commercial locations in accordance with the Rules of the Canadian Electrical Code, Part I.

* For convenience only, the shorter term water heater is used herein.

1.2

This Standard applies to water heaters that provide for the storage of hot water. The water shall be heated by immersion heater elements within the tank, wrap-around or other form of surface contact heater elements, or electrically heated circulation type units located either within the jacket or externally. Other types of electric heating, except as excluded by Clause 1.3, may be accepted subject to investigation.

1.3

This Standard applies to the water-heater section of kitchen units, combined with a cooking range, refrigerator, water pump, etc.

1.4

This Standard does not apply to

(a)   immersion type water heaters (see Clause 2);

(b)   side-arm type water heaters not attached to a storage tank; or

(c)   immersed-electrode type water heaters.

 

1.5

The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only.

 

1.6

In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

 Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.

You may comment on any section of this document by clicking the “Submit Comment” link at the bottom of the relevant section.